How do you use the Crep Protect Spray? A step-by-step guide

Caring for your sneakers is essential to keep them looking new for longer. With Crep Protect Spray you protect your shoes against dirt and moisture. We have created a manual that explains how to correctly use the Crep Protect spray:

Step 1: Preparing your shoes

Make sure your sneakers are free of dirt and dust. If they have just been washed, wait until they are completely dry before applying the spray.

Step 2: Applying the spray

Shake the Crep Protect aerosol well. Hold the can about 20 cm from your shoes and spray evenly over the entire surface. Make sure you don't miss any spots to ensure optimal protection.

Tip: It is recommended to use the spray indoors or in a sheltered environment such as a shed or garage. This prevents the spray from evaporating in the wind.

Step 3: Be careful with the quantity

An excessive amount of spray can give your sneakers an unwanted shine. Therefore, do not spray too much in one place.

Step 4: Dry and repeat

After spraying, let your shoes dry for about 10 minutes. For optimal protection, repeat steps 2 and 3 again and let the shoes dry for another 10 minutes.

Tip: Do a water test after your shoes have dried. Sprinkle some water on your sneakers. If the water rolls off in beads, you know that the protection is effective.

Crep Protect Spray

FREQUENTLY ASKED QUESTIONS

Yes, the spray is safe for use on various materials such as leather, suede, nubuck and canvas. However, it is always advisable to test the product on an inconspicuous area first.

For best results, we recommend reapplying the spray every three to four weeks, depending on how often you wear your sneakers and the weather conditions.

No, once the spray has dried it is completely invisible and will not change the color or texture of your sneakers.

Yes, but it is recommended to let your shoes dry for 10 minutes after spraying. For optimal protection, it is best to apply two layers, with a drying time of 10 minutes between each layer

The spray provides a water-repellent layer , which means that the water rolls off the surface in beads. Although it provides a high level of protection, it is not a completely waterproof barrier.

The spray does not block the material of your shoes in any way, so yes; your sneakers can still breathe.

The spray has a slight odor when applied, but this dissipates quickly after drying. We recommend using the spray outdoors.

This depends on the frequency of use and the size of the shoes. On average, you can completely treat 8-10 pairs of shoes with one spray can.

Yes, shake the spray can well and spray lightly from a distance of 20 cm. Please note that leather is naturally waterproof, so the effect is minimal.

This is caused by oversaturation. If you spray too close to your leather sneakers, you may notice a white film on the surface.

Leather is not a breathable material, so the spray cannot penetrate it, causing the buildup.

If this happens, don't try to wash it away with water. Instead, spray the leather again until it is wet. While it is wet, it will bond with the dry layer. Rub it all in with a microfiber cloth to work it in, protect your sneakers and remove any marks.

Spray from a distance of 20 cm and apply evenly. Do not soak or saturate your shoes and follow the instructions.

Just like most products in an aerosol can; shop it in a cool, dry place away from open flames. The only heat your spray should be near is that of your sneakers.